If my BaT comment, "Re-Spray. 100%" does not get approved, I will re-word it to be more diplomatic. But buyers need to know this is NOT...
Maybe I should be a hired gun / consultant for Auction bidders. Might be something there.
100% respray. And I can prove it's been dropped hard enough on both sides to to fuck up the upper cowl. So many tells on the paint job.
There are some things that don't seem right on this bike. I will do a deep dive tomorrow maybe. But the first couple things... New owner...
This time, let me look for some Honda clamps for you.
Hah! Only cuz I live in Western Washington, but... it's "Everett", not "Everette". :)
They were genuine Honda then? By the way, I work about 7 minutes away from Everett Powersports.
Holy shit. Were perhaps the worm drive clamps a little too "clampy"? Well... that is an intake leak (that gets worse when hot likely) and will...
Next to the Main and Slow Jets, there is a "starter" jet. It can be called many different things, but it is the press-fit tube next to them....
Since it is to be replaced, take a chisel and a hammer towards the edge and start at steep angle. As it drives in, start vectoring lefty-loosey....
[ATTACH] Also consider removing the limiting collars between the tangs on the clamps. At the very least, verify when you go to install the first...
Some grips are designed to go over that ridge. I will often eliminate it so I can snug any grip up to the housing at the gap I want. My 92 VFR I...
I absolutely would fill and sand, that's pretty bad. Wire wheel back down to alum before applying. You can smooth after applying with a gloved...
I don't believe this is a synch issue. And you don't have to be "blazing any twisties" to desire/require good runability. It's actually a safety...
I'm on the lookout for a nice aluminum double clamp. One loop to attach to the subframe above the exhaust mount and one loop for the brake line...
Unfortunately, he has already done that. Twice I think. So the desire to try and "tune it out" and/or hope it gets better is high. Something is...
Just a couple doo-dads to finish up. Still have a brake side wheel dust seal to install. Be here at the end of the week. Thought for sure I had...
Thank you both. I'm pretty enamored. Can't wait to roll out in the sun... and eventually ride it again.
And a starter Upgrade Kit for a stock VFR... [ATTACH]
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] The colors are way off in here and it's cramped, but it was dark and cold by the time I got...
Separate names with a comma.
