I went for a ride today with my air/fuel ratio monitor instrument installed. Very interesting too. It was showing a lean mixture at idle and most...
But my answer is good for a lifetime!
I really like that answer!!! Will do. Thanks LGN001! I asked the question on one of those "ASK the EXPERT forums and the answer I got back was...
Absolute MUST!!! Carb separation Pages 4-8 Honda workshop manual. Carb assembly Pages 4-9 Honda workshop manual. You will not break the plastic...
I was looking at my Factory Honda VF1000R shop manual and I wanted to know the float measurement. Page 4-1 Specifications : USA model .350...
Thanks for the info! That sounds about right. My rear wheel may be just a little smaller diameter than a stock Vf1000R wheel. I was reading the...
Thanks VFRCAPN !!!
I am looking for a air filter housing box for a Vf1000r OR F model. Anyone? Will pay of coarse.
I was hoping you had a shop manual for the V65 1100 Sabre -Do you?
Well this needs more detailed information. If the 85-86 gasket just blocks a coolant hole, a law of physics says you cannot compress a fluid so...
Yes...I agreem, have done it both ways. Either way will work. Master link OR peened regular link ground down just a little.
My bike has carbs. I cannot leave the O2 sensor in all the time because the head pipe is 1-3/8 inch and the sensor blocks about 1/3 of the exhaust...
Today I test rode with the 37 Tooth rear sprocket and 17 front sprocket. Now it is much better!! Low revs at 65 mph and plenty of headroom....
Congratulations on your upgrade!!
Congratulations on all your hard work. There is always a few loose ends just attack them one at a time.
Yes....exactly. Mine is a comfortable rpm in high gear at 55 mph. Would like it to be 65 or higher. So today I bought a 37 tooth sprocket and...
That is the stock style carbs. Wide open throttle works fine. And I have a #40 idl jet which works perfect. If I pull the choke out a little...
I rode it again today with quieter exhausts same style though. The comfort speed was high gear and about 55 mph. Not quite good enough on...
My rear wheel is very close to what yours is. I am getting a 37 tooth rear sprocket, and that will give me 66mph. Low revs. 17/45=2.64:1 then...
It would go much faster but seemed really high revved. I was trying to find its cruise mode. Maybe it does not have a cruise mode. I will ride...
Separate names with a comma.
