A sportbike frame would be fun too. I would make a double loop cradle frame with 30º rake. 4.5 inches trail. Easy to work on and the weight down...
Quadzilla getting restless. I have a polished cover for the rear cylinder head also it is just not on yet. BTW I need a plastic cover for the fuse...
Spray paint the valves gold. Sounds silly but it will look good and make you feel good too. Of course change the oil and adjust preload etc,etc.,....
HUH????:confused: Oh...here's a photo of two of the polished engine covers. Mirrorfinishpolishing did them. perfect job too. Make sure you wash...
Burn out pics? I was just going to post pics of the bike sittin there lookin sassy! HAHHahhahhahha
Thanks Crustyrider! It will be kind of scary to start up. If it runs for any time at all on start up I will be very happy. I tried to put the...
And now for something a little different. Honda VF1000R engine in handmade chopper frame. [IMG] [IMG] [IMG]
Since many of you have grown up with electronic ignition.... You CAN do an ohms check on the plug wires. If the readings are very different from...
Thanks for the link to Speed talk.
OK!!!! The offset sprocket from Germany for my VF1000R just arrived and did not seem to get held up in customs. 7mm offset thats .270 thousandths...
Choppers are all about the looks, the vibe any sport bike will handle way better than a chopper. This frame has 42º rake so at low speeds the...
Using the formulas given in the link above this is what I get. Each intake is about 6 inches to the CYLINDER head. The area of all 4 intakes is...
This looks interesting and very useful. Now I just have to figure intake areas. Intake Runner and Peak Torque Calculator Click on link above.
Something I read recently.... "That depends on what your after? Long runner intakes are for the most part better used for low rpm operation,...
I make things happen. Yes, I have the stock carbs if this plan does not work. I learned that in the military....always have a 2nd way out.
Today i received some valve covers I got from Ebay. Temporary ones until I get the ones I am getting polished. Now I can establish the engine...
I know a lot about this. You are leaving out too many facts. Like boat hull design ,boat length etc,etc.,. First if you already have a prop just...
Not only will it raise up the passenger, if seated, but it raises the center of gravity which is already too high. The lower the center of gravity...
I will think about it, if these give me too many problems. if it starts right up and idles then I can deal with midrange and full throttle after...
Here is a picture of the same set up BACKWARDS!! 2 cylinders- 4 carbs! [IMG]
Separate names with a comma.
