Today I finished getting all the boots and clamps. I got very nice stainless clamps made in Germany from West Marine boat supply stores. The...
I just did not like the stock carbs. I did not like the complexity and those springs between the throttle shafts. I just did not like the whole...
OK...OK... You got me worried so I did the math. Here is what I come up with. The VF1000R if run up to 10,000 rpm. 61cu, ft. X...
Thanks VFRCAPN. That is useful information. I did not know redline was so high on the VF1000R engine.
It is the VF1000R not the VFR. I will check that out too .Thanks. The Formula: VF1000R- 61 cubic inches X 6000 RPM=366000 devided by 3456=105...
The Holly is made for a 350 cubic inch engine and the VF1000 is only 61 cubic inches. But it would look good though.
The Saab V4 engines were 103 cubic inches and ran on one 34mm carb. The Honda VF1000R is 61 cubic inches and should run well on two 36mm carbs.
I understand the concerns about using these carbs but think about this... If the stock engine used a 34mm for each cylinder, and each cylinder...
I do not know how those Holly carbs work but i do know there is a LOT to know about them. People spend many years learning the tricks on those.
Yes the 1500 v twin revs are lower but the mainjets in the carbs are 118's. I will increase those if necessary. I will just have to try and see...
These carbs can feed a 1500cc V twin. They did actually. This engine is only 1000cc. One carb feeds One cylinder at a time. There are lots of...
I am building a bike using a VF1000R engine and I will be using these duel 36mm carbs from a Kawasaki 1500 early model. Here is what I have so...
Here is what I have so far. Just waiting for some special clamps and one boot. The stock rubber boots were hard as a rock and had cracks in them....
I would seriously doubt that there would be a stroker kit for that engine. The bike was not in production that long. A stroker crank would give...
Yes, it is fun to contemplate all the possibilities. With more money I would be in big trouble. I would have a large junkyard at my house. HAHhahahha
You know I thought about that actually but I do not know if those 4 barrel carbs are made to lean on such extreme angles like a motorcycle does....
Well today I found out the guys at the salvage yard did not know what they were talking about -(again). The carbs were NOT from a 750. The...
Yes I agree the new fuel injection systems are much more easily tuned. However the parts are VERY expensive. Like those $1500 dollar garbage can...
Well I put the carbs on but I still do not like them. I also do not like those springs in the throttle cross over linkages. Just a lot of mess and...
OK...Today i found out that th VF1100c valve covers are much smaller than the smaller Vf1000R engine valve covers. They are smaller by about 1...
Separate names with a comma.
