I painted the corroded wheels on my Silverwing scooter, and in doing that I dropped the air out and pushed the tyre bead in a bit so I could mask...
The manual advises (pg 5-73) to screw each starter valve in fully and count the turns, then loosen the locknut to remove them if needed. When you...
[ATTACH] Sorry about the resolution, diagram is from the Honda common service manual. When you press the clutch lever, the piston assembly moves...
You might still have a piece of crud in the piston bore/lines that is getting back to the bleed hole when the clutch has been worked a few times....
It's only been 30-odd years since I owned a VF500F...but I do have the service manual for one. The fuel tap appears to require vacuum to allow...
There is a small steel shield that is pressed in, in the floor of the reservoir. If you pick that out, you will see the tiny port in the floor of...
You'd better tell us what model of bike you are asking about; time for some introductions methinks.
Listen to the Captain, for he speaks the truth!
Here's a link to the manual at the "other" VFR site....
Before you swap out the wax unit, check to see if you have clean flow of coolant through the small hoses that feed and drain it; these block...
Maybe you have filled a cylinder with over flowing fuel from a blocked float needle valve in the carb? Maybe pull the plugs out and see if the...
How the tyre looking physically? No bulges or other distortions? How about the fork bushings, is there any detectable play in these?
Head on over to VFRDiscussion.com and the downloads section; there looks to be a few rear rack instructions there, maybe one will suit you.
Was this just after an oil change? Reason for asking, if you drain the oil, replace the filter and then top the oil up, it will definitely drop...
Sorry if this is teaching you to suck eggs Chris; the oil level when cold/engine off will change dramatically when the engine is running/hot. Oil...
That sounds awfully familiar Samuel, same here. The only exception was when we bought a Vespa to blat around the neighbourhood, my wife quite...
If the fluid level dropped then my guess is the slave cylinder is on its way out and maybe the bore/piston is corroded. Easy enough disassemble...
Sure is. I live in Howick, and quite enjoy the Kaiaua loop. [emoji16] Sent from my iPhone using Tapatalk
Separate names with a comma.
