I presume that is the main fuse, one reason for heat may be some corrosion on terminals, the corrosion increases resistance and resistance creates...
This is the general torque values for the VT250F which I would expect to be very similar to the 400, same general vintage and layout. [ATTACH]
I have the second gear from my RF900 on my desk as a coaster.
Tighten it till it strips, then back off 1/4 turn... 55-65N-m on a VF1000F according to the service manual.
I'm with you on this Randy, I covered 20,000km of bumpy roads on my VTR1000F with a magnet tank bag and it never gave me a moment's concern that...
Sorry to hear about that, hope you're all right. Sounds like you're headed for a bike upgrade (a new VFR, not the scooter).
[ATTACH] This diagram is from the service manual for the RC36, not sure if it is any help to you. Given you are in CA, my guess is that the hose...
So...clutch outer is turned by the crankshaft... Rear wheel turns chain turns output shaft... In my mind I can't picture why all the gears would...
Not really a VFR-related answer, but when I had my 1996 Suzuki RF900R I purchased some Helibars; these were a stepped-tube arrangement and...
The vacuum hose will connect to an intake port under the throttle bodies, and is used to open the oil flow valve for the oiler. As long as the end...
Sounds like you got it sorted. I had CBR954 calipers and CBR600RR master on my VFR and that was a great combo. Smaller masters give squishy brakes...
You're going to have to change your forum name now Captain... That's a beauty!
I actually owned a CBX750F when they were new, and did about 30,000km on it. They were a bit of a stop-gap for Honda after the issues with the...
I think you will find that is silicone grease that is meant to be in that area under the rubber sleeve seal. [ATTACH]
Understatement of the week right there Pete!
I am an Alpinestars fanboy, my current preferred glove is the SP-8, the seams are to the outside so internal comfort is great. [IMG]
Looks like a feed for water to the wax unit on the throttle bodies, which your 98 does not have (this was from 00 onwards, and replaces the manual...
I've visited Philip Island, and ridden at Hampton Downs, Pukekohe, Manfield and Baypark (which is now a housing estate...).
When I was younger I worked part-time at a Honda dealership, and we used a couple of CBX's as shop bikes to run errands on... Those bikes look...
You may also have some corrosion in a connector, I had that on my ST1100 on the red connector which feeds power to/from the right bar switches....
Separate names with a comma.
