Push in on all the brass choke valve. If they move at all, then the choke is not closed. The choke valves are very sensitive and must be...
Put an unlit propane torch near the carb boots and see if the idle raises. If it does, then you have an air leak. You could have the main jets...
Did you remove, clean and set the pilot jets? The pilot jets do affect the entire RPM range, but is mostly affected at idle and just off idle.
That's not gonna work as the fuel in the fuel tubes will flow into the first carb you drain. Now if you measured the second carb, that would...
Clean the electrical connections and grease with dielectric grease. Usually the tach is fed off of the yellow wire from the coils. May be able...
You do my with the engine off.
Your problem is you didn't clean them. The part that get's gunked up is on the bottom. You have to remove the carbs completely, separate them,...
I don't know about the mounting, but I know these will work (3 Ohms is what you need): Accel 140403 Dyna DC1-1 You can also get solid copper...
I took a plastic syringe (get them at Tractor supply etc...) and attached a hose to the end. Was able to get down into the crevices and remove...
The steps in tuning a bike (in order) are: 1. Replace the spark plugs 2. Adjust the valves 3. Carb sync 4. Pilot Screw Adjustment
I don't know if it will sound "better", but it probably will sound louder, as there is no collector to baffle the sound.
Read and learn: wiki.sabmagfaq.org
Adjust the valves, and sync the carbs yourself before you decide to sell it. I'm sure a carb-sync will help - especially if it hasn't been done...
The dry ice only works on dents with no creases and usually on the thin gauge metal used on car panels. I wouldn't think it would work for the...
Roll the bike onto a 2X4 and use the sidestand. This puts a greater angle on the bike and you won't have to drain the oil. You may need a clutch...
I can do it, but I don't. To me, it's not worth the risk of screwing up the tranny. If I'm in a hurry, I just fan the clutch while shifting.
Oil Mod: ValveTrain/OilMod - SabMagFAQ ("DRP" is Dave Dodge of Dodge Racing Products and is the recommended oil mod to use) Get a Clymer manual...
Test the spark on all 4 spark plugs. Could be that the carbs are gummed up from sitting while the wiring was fixed. What was replaced on the...
Sounds like your low speed jets/carb passages are clogged. Maybe a complete cleaning is in order. This may help: Carburetors/Tuning - SabMagFAQ
Sabre does handle better as it has less rake/shorter forks, and the engine is solidly mounted to the frame - whereas the Magna is rubber mounted....
Separate names with a comma.
