What air pressure do you have in the tires? Did you throw a set of strings up and check wheel alignment? How much offset front to rear? Is...
i had a little feller brung me a set of carbs that he swore were clean--he'd had em on and off 5 times and by god they had to be clean, and he was...
How much oil came out when you drained the crankcase--and did it look or smell like it had gasoline in it? i've drained one that sat for several...
please delete please delete i duplicated mac daddy's post by mistake
What? i can't believe you guys didn't send him to the carb cleaning thread... http://vfrworld.com/forums/showthread.php/22449-Cleaning-carbs or...
That is a very important clue to this mystery--Is there anything else that you forgot to mention? What was the reason that led you to decide to...
Doing okay under the mountains of snow?
Yes 2mm displacement to the left will cause it to pull to the right. The BMW have a spec of allowable 'toe-displacement' of 5 to 15 mm, and they...
The BMW K-bikes are notorious for pulling to the right and it wears a flat patch on the left side of the front tire. They are SSSA but have an...
Yes that is the correct reading. If the charger is drawing 12 mA, then in one day if pulls 0.288 A-Hr. And in one month (30 days) it would...
These pictures need to be posted in their own thread to make them easy to find, ease of use, e.g. Inside the Fuel Tank (Pictures)
Go try it again today while it's so cold out and see if it runs longer. And you might try opening the fuel cap and leave it open, just in case...
Check your oil level--you may have added a bunch of fuel to the crankcase if the float needle is not shutting off the flow when full. i've seen...
clean the threads and use rust disolver before messing around with exhaust fasteners. If you are heating the studs to break the corrosion bond,...
It looks like a 1/4 Watt, 10k Ohm resistor, starting at the bottom, Brown=1, Black=0, Orange=3 (x1000), Gold = 5% Tolerance. Radio shack has them.
A Professional mechanic might have a bolt extractor tool which has jaws to grab the stud so it can be backed out. The jaws tighten as the tool...
No it's not the drain line, that is another metal tube designed to drain rain water from the area around the cap. There is a separate tube...
You may want to check all of those components in the vicinity of that resistor, e.g. the zener diodes. Looks like some over-voltage event and too...
No that is not what i meant. There is a one-way vent valve in the fuel cap below the key, but i was referring to the metal vent tube built in to...
Looks like carb bowl vent/overflow tubes, but can't really see the tee on the small diameter tube between the carb upper chambers.
Separate names with a comma.
