I'm planning to replace steering bearings on my 2nd gen vfr700. I'm looking at the pivot works kit (PWSSK-H11-000), from the online photos it...
If anyone is looking for vf500 steering bits I ran across this ebay auction in USA while searching fork bushings. The price is right, you will...
The same style used on the rc24 and other models...
I've been electroplating small parts for the past few years. I agree its not really a time saver but I am working on the assumption extra time now...
Well brake rebuild didn't finish by year end. The hand controls and master cyls were cleaned up earlier, including new sight glass. It appears...
20191109_153211-0.med by chuntera posted Nov 10, 2019 at 11:39 AM Toasty Acorns
I decided on the Galfer, kit which I haven't installed yet. I might reuse the metal lines that crossover the front fender.
Well its fall again, and I realized I haven't updated this post. Actually I've only logged into vfrworld a couple times over the summer :/...
I have a '99 5th gen Last year I rebuilt the rear brake caliper, added a speed bleeder and swapped in new SS brake lines. After flushing the brake...
thanks, long ways to go before I have a whole bike
Well "until fall" became spring but the heads are back together. I lapped the valves & installed new valve seals and cleaning...lots of cleaning....
I got one of his kits last week. Easy job to do while your checking valve clearance. [IMG]
you can check the disc rivets or what this brit guy calls "bobbins" [MEDIA]
Just to be different, I installed another brand RR. I used a polaris 50A series RR (PN 4016868). A 4" steel plate used as an adapter to mount the...
That was my thought also. There wasn't clearance between the frame & cable bracket for a screwdriver. Next time I will pop the throttle body out...
I am relatively new owner of a 99 5th gen vfr800. I have been riding a 2nd gen vfr700 for past 10 years or so. My 5th gen needs a new thermostat....
If you go with the solid state fuel pump, get one with a "positive shut-off valve".
got the crankcase halves back together. Compromise was necessary to move this project forward (I needed to reclaim my workspace). I swapped engine...
You could 3D print some lower fairing stays, those are impossible to find.
Yeah, I thought about using an 87 head but decided too much work and will go with head from an 86 motor. I was hoping to use the rocker arm...
Separate names with a comma.
