I did my 5G last year, and that was pretty easy. You need a new gasket, and need to make sure the judder spring/washer go in the right...
"Isn't that a bit pedantic?" "You can't be a bit pendantic....
Yeah, I agree. Sent from my iPhone using Tapatalk
Tested out my 8-spoke back wheel with a 250km non-stop run through the spring sunshine. I think it unleashes all of the full factory potential of...
If the problem stayed on those cylinders, then the fault would be in the supply or ground to the coil primary circuit. Does the 1000F use two CDI...
My only front flat was on a CBX1000 six cylinder in 1983? Noticed it feeling a bit weird on the motorway, stable enough but hard to turn. Pulled...
Fixed that for you.[ATTACH]
This column is written by an Aussie bike journalist called Boris, I've been following it on FB all year (called "Dear George"). Very often...
Before you go to the trouble of pulling the TB's off, why not let then engine get hot (so the heat will soften the inlet rubbers), then slacken...
The only reason that the throttle bodies/idle screw won't line up with the frame hole would be if the TB's are not sitting down onto the intake...
Best wishes and heal fast Jay! Having damaged my ribs, I can vouch for the pain of sneezing, so stay away from pepper for a bit. Puts the risks...
Change your colour scheme to VFR Dark, via your profile page, and preferences.
Genius, thanks DP!
You are unlikely to get a short along a wire unless the insulation is damaged, but very likely to get corrosion at the terminal contacts that...
I get that the man was walking, but the python??? Surely that would be being taken for a slither? How do you even keep a collar and leash on a python?
I believe this is a 6G? Things to check would be the sliding pins for the caliper, these need to be clean and well greased. Next up would be a...
Hmmm, where to begin??? Assuming you just replace the fork tubes, you should go for re-springing and re-valving. That will make a massive...
Your suggested fix should work fine (provided the triples themselves aren't bent), but you will need to slacken off the bottom triple clamps,...
This is a cheap voltmeter, I found a plastic irrigation hose fitting that is snug in the steering head, and cut two slots in that to accept the...
A weak spark can give those symptoms, so try new plugs first, then maybe check the resistance on the coils and plug leads, and confirm you are...
Separate names with a comma.
