How old is the battery and what is the state of charge/ electrolyte specific gravity/ electrolyte evel? Check all the ground connections...
On fuel injection vehicles the butterfly valve screw is almost always set at the factory and then locked in place with some sort of high strength...
So now you've started another new (at least the third) thread about the same bike not running good. If you don't keep all the facts, and notes,...
May want to post this in the 6th generation forum also. Seems like only an exhaust leak could heat up a tire that hot and that you would hear it...
It seems like the pulser may be working although the voltage sure is at a low level--?, but i'm not sure what voltage level would show up on a...
If you intend to work on your bike or fix it, then you need to get a copy of the factory service manual and read it cover to cover. Do a search...
Your idle speed may be a little too low. Sounds like vapor lock of the fuel lines with high temperature, maybe the routing of the lines.
ain't them prairie dogs just little furry pigs? more fun than squirrels? required on topic discussion: some meters use the positive lead as...
the brushes in the motor must be missing or not touching the commutator since it turns freely yet putting 12 v on it doesn't move. When the...
see if you can turn the fan by hand, then squirt wd40 or other lube into the bearings--once you break it free it can still have some life left...
What is your idle speed setting? How many turns out are the mixture screws set? What size pilot jets?
Does your meter have a diode function ( looks like an arrowhead with vertical line at point, ->|- ). If so use that to test the RR. 1....
You didn't say, but did you have a wreck while riding or did the bike just fall over on the left side? If a fall over: Slightly bend the...
And promptly blew... Electronic modules do not like to have the ground open--the electrons are looking for a path back home and if there is...
i can't verify the wiring for you, but someone put a Y on that coil near the green terminal and there is a Yellow wire connected. i suspect the...
@amc You should start a new thread to get answers for your specific issues, just saying...
You are it! pays off persistance does--vfr master you are... Great catch on finding the sensor.
A lot of times the cheesy bearings (plain sleeve bushing) in the fan will rust up and lock the shaft. Try to rotate it by hand and feel if it is...
Since somebody got stupid with the wire cutters all bets are off. Verify continuity of the wires from the ICM to the coils. If you can try...
It would have been nice if they had made the petcock easily accessible without dismantling stuff. Damn Alky-hawl fuel doesn't help matters...
Separate names with a comma.
