It's doing it at high speeds also, but at high-frequency the amplitude gets attenuated by the damping of the fluid. You just notice it more at...
Now you're scaring me--what makes you think you know what size drill bit would fit? The jet is not the ~1/16" opening on the end of the...
Charge up a battery, either old or new, and install on the bike. Then connect a clamp-on current meter around one of the battery cables and...
Yes i think you are correct since "A" is the vacuum port.
a #12 electric guitar string is hardened steel with a spring temper and works best to clean out the pilots and the choke. It should go several...
Seems to be going around a lot lately, hope it's not contagious...Good pictures and vacuum and vent hose routing here:...
C is a manifold vacuum port. There is one on each cylinder and they are used when synching the carbs. D is a barb fitting in the manifold...
The holes in the sides of the pilot tube are air jets to create the fuel emulsion. There is one very tiny hole thru the central axis that is the...
a #12 electric guitar strimg will be your best friemd here to cleam out the pilot jeys.
Using the search function i found this thread in the forums: http://vfrworld.com/forums/mechanics-garage/22449-cleaning-carbs.html Carbs don't...
Clogged pilot jets in the carburetors. They are a very tiny orifice (0.013") so any little bit of paint or crud in the fuel can shut them down....
i've never seen one do that either. i think your assumption is good--the maths may be a little off cause the sprocket is more like 3 inch...
You have at least two problems here: The axle should be installed from the sprocket side. You are missing the bushing that rides in the slot of...
Do you think the cut wire was from the tip over, or how?
Some things you could try: Hook up a voltmeter to measure the voltage on the red/yellow wire at the fuel cut relay. When you turn on the key it...
That was a smart move to check for fuel in the carb bowls. The fuel cut relay, aka fuel pump relay, gets its control signal (red/yellow wire)...
Sorry to hear that it got dropped. Chances are that you are just super sensitive to every noise right now. As long as it is shifting into gear...
!st gear WOT acceleration is the quickest, and subsequently it has the highest fuel flow rate and torque load on the clutch and transmission. You...
i just love a good mystery... :popcorn: :spider:
Based upon your last ride report, It's not gonna be the return orifice -- it'll be rounded off edges on the ends of the 2nd gear dogs. You...
Separate names with a comma.
