They certainly look good but I have no experience with them. I bought myself a set of 25mm drop adjustable pegs recently (free international...
That does sound plausible to me; fuel has a nasty habit of gumming up the mechanical parts if left sitting and evaporating for a decent length of...
I get exactly this symptom, sure to be the brake pads rubbing on the disc. My one makes a little moaning sound, which I take to mean it only likes...
The vacuum in the intake is used to lower the regulated fuel pressure; this is so the difference between the injected pressure and the air...
These are what I had on my Suzuki RF900; I did have to do a little filing on them to fit, but they were great....
In my experience a bit of brake drag is normal for the VFR. If you jack the front end off the ground the front wheel should be able to spin for a...
My Japanese market 1997 VTR1000F had a single pink/green wire screwed onto a terminal on the back of the speedo; I pulled that off and, hey...
Looks like a great day for a ride, Jorge. I got out for a calming 300km ride in similar weather on Saturday and killed a lot of insects! Covered...
Well you're going to have to fully disassemble the fork to do the seal, so replacing the bushings is very easy at that point. If you have the...
The fuel pump and injectors don't normally given any bother, but a 14 year old bike that has only covered 4558 miles has been sitting unused a...
I picked up a set of lightly bent VTR forks last year for $200 NZ pesos. Sent from my iPhone using Tapatalk
VTR's use a 17 x 3.5 front wheel, the same size as the VFR. Ideally you should keep your VFR wheel and discs, just swap the fork lowers and the...
+1 on the Corbin. An old girlfirend bought one new for her bike way back in 86.
You know, you're going to confuse the folks in the Northern Hemisphere by posting your photos like that: [IMG] They really should be properly...
The problem you face is that your bike has sliding calipers, which mount onto a second plate with the sliding mounts, which then bolt to the fork...
Good idea on the Buell pegs. I had a set of 1" lower pegs on my RF900 and they were great. Took a bit of file work to fit but it is only alloy so...
I'd say the 99 data is 'as tested' by a magazine, where the other two are Honda's quoted data. As far as emmissions "crap" goes, only the...
Sorry that I can't help you with a simple answer, but calculating the spacer length is not hard. Install your springs and the two flat washers...
Just FYI you can take the clutch cover off without draining the oil, a long as you keep the bike on the sidestand. Don't over-torque the clutch...
On my VTR (which uses a very similar design to the VFR) I replaced the roller bearing and bushing that supports the clutch outer on the gearbox...
Separate names with a comma.
