Yes I have new ones. I've tried the old ones and even swapped the needles and seats from the front carbs. No difference.
Yes I'm bench testing and if I'm not mistaken adjusting your way Capt would make the float height lower.
Well it really won't matter if I can't get these rear carbs to stop leaking. I confirmed the the valve and seat stop the flow. I raised the float...
It can be changed easily. I'd like to try it.
I went ahead and installed sprocket and chain and sprocket cover. Then installed peg bracket and gear shifter. [ATTACH]
I'm getting oil supply to the top end now. I ended up poring about 6oz of oil into the rear supply banjo with a tiny tube I had. Took an hour for...
[ATTACH] Exhaust pipes on, Valves lash checked again and valve covers on. I pored oil in the top end friction points and buttoned it up. I'm...
No but I haven't put the valve covers on so I should have acc
Right side breather hoses, clutch, rear wheel brake lines.[ATTACH]
Back on 2 wheels [ATTACH]
[ATTACH] [ATTACH]
Well I finally got the engine in the frame. What a nightmare. I didn't realize that the 86 frames were different then the 84. The rear head was...
Carbs are done with 6-Sigma kit installed. Picture taken on rubber mat so as not to upset Squirrelman. [ATTACH]
Moroccan actually. My wife was born there. She said I could put it in my room. The house is hers but I figure the garage is my room so I put it...
The Top end is Done ![ATTACH] [ATTACH]
THIS is EXACTLY what I was looking for. I'm so grateful Capt. You just made my week. I've already got that one mounted. Now I can prep for...
Nope. Tried that many times. I', going to order another A guide to see if that will work.
This is the only way the guides can be installed without interference with the case. Note that the guides are both on the same side and not offset...
My hand is holding the tensioner in it's widest opening and it won't fit under the case where the mounting screws are. The other tenser is mounted...
I must be missing the obvious but I've tried so many ways to install these tensioners in the lower block so that they properly align with the...
Separate names with a comma.
