So it sounds like you wnt to accomplish 3 things: 1. Lower the bars 2. Improve the suspension and 3. Ditch the linked brakes I can't really...
As I understand it, the U-shaped tube you are referring to is the fuel return line from the fuel pressure regulator. This directs fuel back at the...
The brown/black wire should reach to earth through the ECM if it is trying to power the pump, so assume you'll get 3 seconds continuitiy to earth...
Not sure on the expected fuel pressure with the vacuum hose connected but the purpose of the FPR is to keep the fuel rail pressure constant with...
No experience of this with a Honda but 2nd gear is pretty weak on many Suzuki 4-cylinder bikes from the 90's. My RF900 started skipping out of 2nd...
The purpose of the one-way valve is to use intake vacuum to charge the vacuum chamber on the front of the airbox, and then the ECM opens and...
If the wires got hot and the pump did not run when you did a direct 12V connection to the pump, it sounds most likely the pump has seized. [ATTACH]
I assume you are referring to the front forks? The service manual refers to using ATF (automatic transmission fluid) with 332mL right and 335mL left.
The issue of mechanical noise is very individual to bikes, designs and riders (and possibly even the helmet that you use). I do believe that the...
The 700 is really a 699 to avoid the tarriff that Reagen imposed at the request of Harley. I believe the 750s were always sold alongside the 700s...
The service manual can be downloaded here:...
That is the one-way valve that operates the flapper via a solenoid valve. If the ends are uncapped you will have a vacuum leak into an inlet port...
I know my 5th gen really dislikes an idle that is too low, and will stall very easily if the idle is much below 1200. My first suggestion is to...
That sounds like clutch rattle to me, and that is neither a concern or unusual. The idle sounds quite unsteady and suggests the carbs might need...
The SMC can get corroded if the rubber boot gets degraded. There is also a one-way check valve and a compensation port in the SMC that can block...
I did that (delink) on my previous 5th gen and Mellow did it before me. I fitted CBR600F4i forks and front brakes and was happy with the outcome,...
This is the most relevant file.
Brake bleeds don't go bad unless you get air in the system. The link that I sent (from the St1300 page) has a few tips on chasing air out of the...
I would not say that you need to do rear pads just because you bled the brakes. My comment was that you can end up with the same symptoms if the...
Ok, it sounds like we did basically the same procedure. Did you change your back pads as well? It is unfortunately fairly easy to do as I...
Separate names with a comma.
