which was what ?
i'm impressed alot with the engine work you've done to rescue that '87 !!!!!! hoping it works out well.
FREE !! :Cheer2:
[MEDIA]
i wish the guy who sent me carbs from a vtr250 to clean knew that...... [ATTACH] this is exactly what he sent me :nelson:
^^ no steve the carbs will come off easily unless they've been on since forever. loosen clamps on both sides of the boots. [ATTACH] what's...
^^ yes, fuel crossover tubes need new O-rings. use viton -.012 rings available from any industrial bearing supplier. takes time and you will...
same part :D seller is ignorant trump voter. it's important that the filler neck isn't damaged or the cap might not seal properly.
i tried but their little hands were too weak [ATTACH]
who, me ? [ATTACH]
wait.........u still haven't gone in and checked the valves ? check for bad adjustment or broken valve springs on #3.
maybe there is a small crack in the float valve seat area that lets uncontrolled fuel into the bowls ? is fuel emerging from the hole under the...
replace the flattened adjusting screws, jim, as the distorted bottoms won't hold the adjustments long.
TOO DANGEROUS :eek:
there's always some nasty-smelling disgusting liquid silver particle soup fouling up the bottom of old forks, so it's best to remove them, wash...
^^ jam the gears with a penny or a rag
check for a bent front wheel and bad wheel bearings, bent axle, damaged steering head bearings, bent triple clamp, all things that may be damaged...
remove all the fuses (not the main 30 amp) then plug them in one at a time to find the circuit that's shorted.
maybe a mouse chewed some wires and caused a short to ground ? [ATTACH]
and it ran ok last when ?
Separate names with a comma.
