https://www.facebook.com/tony.murphy.587/posts/10156665890479848 Sent from my iPhone using Tapatalk
Wow, that's an impressive first bike! This was me: [ATTACH]
Regarding Phillips head screws, you will probably find that the screws used on the VFR are actually JIS (Japanese Industrial Standard) not...
The original sliding piston calipers are not bad brakes, and provided they are well maintained (clean seals and pistons, lubed slider pins) and...
I was going down the carb/fuel path on my ST but even though I was sure the carbs and fuel lines were all clean, the problem persisted. You...
Does this model have a vacuum petcock for the fuel? If so you might check there and make sure it is functioning properly as if not you can get...
I like the suggestion of using the rotor to push the pistons back a bit. Will add that to my repertoire. Certainly better than my usual method of...
The tip-over switch is located under the instruments, and requires a tilt of >60 degrees to activate. I would expect that in any normal bit of...
A low idle might be the idle adjuster, but my guess is it will more likely be dirt in the pilot jets. If the adjuster doesn't help then that would...
The FI light is trying to tell you that it is not happy with an input from a sensor. The flash pattern is a code that can be read to determine...
The power feed to the fan motor is always "live"; the thermoswitch just completes the circuit to ground. You should always see battery voltage on...
The Oxford HotGrips which I have installed have individual heater tubes with a wire lead that connects to the harness from the temperature...
I'm 100% sold on the LEDs. I don't do a lot of night riding, but when I do the extra illumination is a huge bonus. All three of my bikes put out a...
Yikes, I've never seen anything like that before. Good job landing that one safely. I think I'd be sending that one back to Michelin for analysis....
Found something else to fix today; on a 300km bumpy road ride I noticed the instruments/mirrors/top fairing jiggling a bit more than usual. Turns...
The Police in any country do an incredible job and deserve our respect and thanks. Having dealt with my local community police this week in...
Not sure about the VFR12, but the final drive filler cap on my VFR1100ST (OK, 1990 ST1100) is the same part number as the valve access cover for...
Personally, I think you posted those picture just so we could glimpse all your other, drool-inducing collection!
Posted in the 5G section so I'm guessing..... The earth block is an approx 1" long rectangle taped into the main loom on the right side, below...
There is a diagnostic procedure in section 5 of the service manual. On the wiring loom there is the "service check connector", basically a black...
Separate names with a comma.
