Search Results

Search Again
Page 6 of 10
  1. Terry Smith
    Post

    Prince is dead.

    I have some more bad news for you then: [IMG]
    Post by: Terry Smith, Oct 23, 2016 in forum: Anything Goes
  2. Terry Smith
    Post

    5th Gen....HEEELP....lost clutch

    Genuine Honda parts are always a good idea in situations like this. You can order from the local Honda dealers, or do as I do and order from...
    Post by: Terry Smith, Oct 22, 2016 in forum: Mechanics Garage
  3. Terry Smith
    Post

    Greetings from Auckland NZ

    Welcome, fellow Jafa!
    Post by: Terry Smith, Oct 22, 2016 in forum: Introductions
  4. Terry Smith
    Post

    Idle speed?

    On a 6th gen, the idle adjuster is a black knob hanging down over the clutch cover on the right. 1200 is the number specified in the manual.
    Post by: Terry Smith, Oct 22, 2016 in forum: 6th Generation 2002-2013
  5. Terry Smith
    Post

    Am I right in thinking its reg/rec failure???

    When the reg/rec fails, either the battery stops charging, or it gets over-loaded and boils out. Your symptoms do sound like a flat battery, so...
    Post by: Terry Smith, Oct 20, 2016 in forum: Mechanics Garage
  6. Terry Smith
    Post

    Thermostat/radiator temps

    There is a small breather hose running from the thermostat housing to the right radiator which is always open (and is there to stop the thermostat...
    Post by: Terry Smith, Oct 20, 2016 in forum: Mechanics Garage
  7. Terry Smith
    Post

    Noise from engine/tank area at 5000 rpm and 6500 rpm...

    The flapper uses engine vacuum to open, but that is controlled by an electric solenoid, by the ECU. 5500 rpm is where it should operate. I don't...
    Post by: Terry Smith, Oct 17, 2016 in forum: Mechanics Garage
  8. Terry Smith
    Post

    what did you do to your vfr today?

    I seem to have more use for the Dopeler effect, in which stupid ideas seem more sensible when they come at you rapidly. Sent from my iPhone...
    Post by: Terry Smith, Oct 17, 2016 in forum: General VFR Discussions
  9. Terry Smith
    Post

    5th gen shutting off after hard braking

    This is a 98 so should have manual fast idle control, not the wax unit. Sent from my iPhone using Tapatalk
    Post by: Terry Smith, Oct 16, 2016 in forum: Mechanics Garage
  10. Terry Smith
    Post

    what did you do to your vfr today?

    Nice picture AM. Apparently due to orbital variances, the moon is at its closest approach to the earth right now hence the extra illumination...
    Post by: Terry Smith, Oct 16, 2016 in forum: General VFR Discussions
  11. Terry Smith
    Post

    5th gen shutting off after hard braking

    The FI system will not work (at all) without the fuel pump; injectors won't inject. However I can confirm that fuel will happily pass through the...
    Post by: Terry Smith, Oct 16, 2016 in forum: Mechanics Garage
  12. Terry Smith
    Post

    Front end lift/stand for a rotor change

    You might want to check whether you need new rotors first. The steel discs are usually OK, but the aluminium carriers can get bent really easily...
    Post by: Terry Smith, Oct 16, 2016 in forum: 6th Generation 2002-2013
  13. Terry Smith
    Post

    G5, amb air temp sensor replacement question

    It's probably a sensible position when there is a steady stream of air from movement, but it will be hopeless when stationary. Sent from my...
    Post by: Terry Smith, Oct 14, 2016 in forum: Mechanics Garage
  14. Terry Smith
    Post

    G5, amb air temp sensor replacement question

    Best of luck with it. If you were keen, it is possible to check the air sensor for a fault, according to the service manual the resistance...
    Post by: Terry Smith, Oct 13, 2016 in forum: Mechanics Garage
  15. Terry Smith
    Post

    G5, amb air temp sensor replacement question

    Beat me to it Zoom-zoom. I was thinking that just the right side lower needed to be removed.
    Post by: Terry Smith, Oct 13, 2016 in forum: Mechanics Garage
  16. Terry Smith
    Post

    G5, amb air temp sensor replacement question

    I'm late to this party, but the sensor IIRC is clipped to the inside of the inner cowl. I would first try cutting off the old sensor, and splicing...
    Post by: Terry Smith, Oct 13, 2016 in forum: Mechanics Garage
  17. Terry Smith
    Post

    Memeing It Up!

    [IMG] A nice follow on to Lint's post above. Sent from my iPhone using Tapatalk
    Post by: Terry Smith, Oct 12, 2016 in forum: Anything Goes
  18. Terry Smith
    Post

    Hello VFR friends

    Zdravo, Sale. Welcome to the forum, nice pictures.
    Post by: Terry Smith, Oct 12, 2016 in forum: Introductions
  19. Terry Smith
    Post

    Memeing It Up!

    [IMG] Sent from my iPhone using Tapatalk
    Post by: Terry Smith, Oct 11, 2016 in forum: Anything Goes
  20. Terry Smith
    Post

    800 VFR mileage

    I get about 260-280 km to when the last bar starts flashing on my 5th gen, but that is having lots of fun on good roads, no commuting or droning...
    Post by: Terry Smith, Oct 11, 2016 in forum: 6th Generation 2002-2013
Showing results 101 to 120 of 199 Next >
Search Again
Page 6 of 10