You can pick up an ignition on power feed from the rear brake light wire
You have obviously disturbed a wire that was grounding out, but don't worry it will get you again one dark rainy night :wink:
I'm pretty sure they all sit flat, it is that they sit at 80 degrees to the centre line of the bike
Never looked before but that is where my 86 sits about 80 degrees
Put another fuse in and see if it blows straight away, if not move the steering from side to side and if it blows you know the problem is up the...
But in this case he is not fitting the stock pump so it is an unknown. Just refer back to the posts regarding "VFR getting the boot, new Ninga in...
Couple of problems with fitting a ball valve, you have to remember to shut it off and there is nowhere you can fit it so that you can get to it...
So while you are playing with wires, get yourself a fuel shutoff solonoid because this may prevent a fuel hydrolock in the future and trust me it...
Hi Randy, I'm in Victoria which is in the south and I guess there is snow up in the Alps because it is bloody cold down here at the moment and the...
If it is only a hole through the tank, make up a patch out of a bit of plastic and JB Weld it on. Should hold ok till you can source another and...
Tink, The youg bloke doesn't look anything like a Tassie Devil, I have seen them in the wild:smile: ...
No war here Randy and I think we are still in the Commonwealth, but on a final note I use JB quite often and it has probably let me bown a couple...
It even made the news in Aus but we only go the short version, was good to see the end result
Another thing I was a little surprised about with the JB Weld, I had 2 of those semi flexible, semi rigid flasher stalks that had snapped off....
I have used JB Weld inside a motor where the case had broken a large section of the timing side bearing housing away. There was plenty of oily...
Any news smack doogle?
I bought 2 Motorbatt batteries a couple of weeks ago and both sit at 12.4volts so buggered if I know
Is there any particular models that have this crazy overcharging issues. Does anybody make a rec/reg that can handle this voltage or is it just...
As long as you are aware that any second hand motorcycle can ruin your life
I always thought that 12.4 volts was about right for a sitting battery, I have never seen one sit higher than that
Separate names with a comma.
