Don't forget to count them. Good luck.
Be very careful with chain. I advise against using it in any tank that has internal piping. It can wrap around and tie itself in a knot......
If needed, I am fortunate enough to have a true, old school radiator shop about 20 minutes away. Not many of them left around. When I'm...
That's great news. Typically approx 20mm of preload is standard for the correct rate springs, so you me be a little heavy in that department......
Turn a pilot screw in: Leans it out. Better for altitude Turn a pilot screw out: Richens it. Better for sea level But this marginal in...
My favorite 80s saying. "I couldn't afford NOT to buy it!"
[ATTACH]
I buy replacements off eBay and solder into the harness, trimming back any corroded/burnt wiring.
The small "T" fuel fitting is a keeper. They are super fucking brittle now and often break if you just give them the stink eye. Be VERY careful...
Something ain't right. And it feels like more than a needle shim and 1 step on a pilot. Sounds like it runs ok when it is pretty much all main...
I think after looking at a bunch of other ones, it was a way to track how many times and when the molds were used to produce a run. I've seen...
Jump the Fuel Cut Relay as a test too if everything else checks out. While they usually just fail, they can be intermittent when failing. I had...
Interesting. Thanks for the report.
I found this to be a much nicer tool with a cleaner interface. I only use this for the "Where Used" function. I tend to go to Babbits Honda for...
And there ya go.... But linkken, that is a very tough question to answer. The only way to find out is to package everything, and that's a lot of...
"One man's junk..." Certainly not junk, but shipping parts like this is the killer, right? Not sure how the 3rd Gen scene is in Winnipeg,...
A "feature" that I don't mind paying for (in my Arais) is ALL DAY COMFORT. Even if a helmet fits your head shape properly, it doesn't mean it's...
You need to locate the starter relay. Pretty sure the Main Fuse is located on the housing on your model and would kill power to the whole bike as...
It's interesting that even their instructions state (and diagram shows) that the valve goes ON TOP of the piston "and must cover it completely"....
I would also go 6 each, and I do when I perform this step. You can't have too much flow to the Emulators, but not enough is defeating their...
Separate names with a comma.
