Poke, prod, spray, soak, blow, hope, curse, maniacally laugh. Drink.
Yes. Likely clogged then. If you have anything finer, try that too tho.
My second comment was published. Other items include: Rear cowling is broken at both L & R lower mounts above footpegs. Front headlight surround...
They are generally decent. Some have better engineering than others. These were actually badged and sold under different names, but they are the...
I tried to leave a comment again. A little lengthier this time.
If my BaT comment, "Re-Spray. 100%" does not get approved, I will re-word it to be more diplomatic. But buyers need to know this is NOT...
Maybe I should be a hired gun / consultant for Auction bidders. Might be something there.
100% respray. And I can prove it's been dropped hard enough on both sides to to fuck up the upper cowl. So many tells on the paint job.
There are some things that don't seem right on this bike. I will do a deep dive tomorrow maybe. But the first couple things... New owner...
This time, let me look for some Honda clamps for you.
Hah! Only cuz I live in Western Washington, but... it's "Everett", not "Everette". :)
They were genuine Honda then? By the way, I work about 7 minutes away from Everett Powersports.
Holy shit. Were perhaps the worm drive clamps a little too "clampy"? Well... that is an intake leak (that gets worse when hot likely) and will...
Next to the Main and Slow Jets, there is a "starter" jet. It can be called many different things, but it is the press-fit tube next to them....
Since it is to be replaced, take a chisel and a hammer towards the edge and start at steep angle. As it drives in, start vectoring lefty-loosey....
[ATTACH] Also consider removing the limiting collars between the tangs on the clamps. At the very least, verify when you go to install the first...
Some grips are designed to go over that ridge. I will often eliminate it so I can snug any grip up to the housing at the gap I want. My 92 VFR I...
I absolutely would fill and sand, that's pretty bad. Wire wheel back down to alum before applying. You can smooth after applying with a gloved...
I don't believe this is a synch issue. And you don't have to be "blazing any twisties" to desire/require good runability. It's actually a safety...
I'm on the lookout for a nice aluminum double clamp. One loop to attach to the subframe above the exhaust mount and one loop for the brake line...
Separate names with a comma.
