Man, the U.K. sure has way more specific vendors and resources for carb parts than here in the States. That's a great lead Thumbs, thanks.
Paint scheme says 85. So does the updated forks and calipers. Looks pretty damn nice.
It looks legit and I'm sure it is. I order used ones off ebay. They are Mitsu pumps, but I look for ones with straight outlets off applicable...
Wow. How much was that pump? Edit: Yikes.
I have so many goddamn bikes, I can't afford to throw all new parts at everything, every time. An original float valve that passes inspection and...
[ATTACH] The wire bundle under the rubber boot to the right in this pic comes from the battery side near the solenoid. BLK/BLU - BLK - YEL/GRN...
1/16" thick, textured on one side. [ATTACH] I reinforce the top mount with some thinner ABS so the rubber bushing will still fit. [ATTACH] I...
I have NEVER had to replace the Viton tipped float valves. Put a little lacquer thinner on a rag and spin the tip between your finger and thumb....
What's their angle?
It senses signal from ignition and allows the power to continue thru the harness to the 2 wire pump connector, and that has a ground. As far as...
Hey, I'm winterizing one of my VFRs tonite and removing the rear cowls to snap some pics for something else actually. I'll snap some pics of the...
I'll try and post one tonite. I need to winterize my white 86 anyway, so I'll have most of the cowls off already.
I "Plastic Weld" Epoxy in a horseshoe shaped piece ABS I cut out of a sheet that goes around the front of the taillight on the inside of the cowl....
The issue with the Vacuum Petcock failing is that it tends to continue to kinda work while it dribbles gas and destroys some finishes as it weeps...
I don't think he's going to use the muffler, moving to a straight thru design, but I can't argue with that. Cool.
If somebody thought that the screw needed to be 4 turns out, I would up the pilot for sure. 1-3/4 to 2-1/2 is the sweet spot. Sometimes when the...
I would go up on the pilots. Mains not likely critical, I agree with thumbs, but if it was my carbs with that exhaust (planning on a thru race...
The 90 - 93 VFR didn't even get a center stand in the states as new. And the Hondaline kit was an abomination. This huge slab of steel bolted to...
I almost bought that caliper and bracket! Good deal.
That is where I order all my decals. Here's some I had custom made for the 95 VFR. I'm going to have them do my Hawk decals too. [ATTACH]
Separate names with a comma.
