Were you? I don't think so. The fact that you think so is interesting.
2nd gear can be replaced without removing the heads or crank. I would 100% go make him an offer.
Hey, I'm gonna update my rear brake thread tonite with what is probably my favorite route. And then I have one more good one after that too.
I was just telling my friends that I liked a lot of people a lot more when I knew a lot less about them. There are quite a few people in my life...
You could try one of the Chinese ones. I have read more positives than negatives, but sometimes a mounting tab can be in the wrong place. I...
With the plugs out the motor should turn over pretty easy.
Stray, please PM his info. I'm thinking a Rothmans might be needed.
100% ABS
450. I test rode the bike with a 380mm D&D can and it was a bit too gnarly on this exhaust. I know they are not the same can, but it was the...
Shitty pic [IMG]
The Tyga I put on the RC26 is beautiful looking and sounding. And was reasonable. [ATTACH][ATTACH] [ATTACH] Mount it where you want it and have...
Sounds like their ERP system is dated. That should have instantly showed as NLA when ordering.
Yeah 17 x 3.5" rear from a 1988 or 1989 VFR is bolt on. I tried a 87-88 CBR1000F rear wheel that looks identical, but it's not even close.
Float chamber vent lines on a California bike. As long as the main breather that comes off of the plastic vent cross-over tubes is being vented...
https://www.ebay.com/itm/334171270539
https://www.ebay.com/itm/334171326450
They are fairly non-serviceable. Now... anything is possible, but not even the rubber gasket is designed to be replaced on these caps. I did do...
And a drift to stake it.
Try and do as much carb work at one time as you can. It helps. Also, consider pulling just one carb off of the plenum and verify what size the...
1. Yes 2. Yes. Race type fiberglass bodywork. Fairly thin and requires lots of prep and attention to detail to look really good. 3. See #2,...
Separate names with a comma.
