Perfect fit and chain alignment is spot on. It was a huge relief to see that my calculations and measurements were good. The slightly sucked in...
Cool then! Good luck! Ironically, Bellevue WA is about 20 minutes from me.
Problem is it's not just an o-ring.
https://www.ebay.com/itm/HONDA-FUEL-PETCOCK-REBUILD-GASKET-KIT-VF500F-VF500-INTERCEPTOR-1986-/362160085717 I think there are other sources too,...
[IMG]
Thanks. I like the finish, might have to find some and experiment.
Nice bit of progress. Good job! What did you shoot the valve cover with?
1st or 2nd unless its under 40 degrees. Then 3-5.
Me too! [IMG] https://vfrworld.com/threads/xl600r-motard-urban-assault-dual-sport.56461/
Finally got the lathe setup up at work. I took 9mm off of the sprocket mount face, modified the VTR1000F inner hub spacer to suck the hub in a...
All of the above. The CBR F1 caliper bracket might need different spacers, haven't verified that yet. You will need to bore out to 20mm for...
Then it's just plain stuck it seems. I would soak it upside down for a while. And maybe introduce a little heat. Shoot.
Im not at home, but look at the bottom of the fork right below that on that same boss. Anything there?
I would start with their suggestions (preload and oil level), you can adjust later pretty easily with the right tool. [IMG] You can get some...
So pretty... loving it. Great work.
It will fit just fine on the 87. If you are inquiring about your mechanical ability to do it... who knows. A spring puller would be good....
Separate names with a comma.
