Had it outside to run again, took advantage of the better light for a photo op... [IMG] [IMG] [IMG]
Very nice! Good job.
[IMG] Changed some things up on this one so they weren't the same. Rearsets powder coated to match frame/forks/swingarm/upper triple clamp. Side...
Some years back a couple Harleys did show for the Tiddler. They weren't publicly shamed enough by people and went on the ride. Friend of mine...
Yeah, the CA160 (not technically a Dream). They scoot along pretty damn good. The 150 and 160 rev pretty high (10,500 RPM redline on the 150!)...
Since this is your thread, here are some of my vintage bikes... [IMG] Left to Right: 1967 CL90 (X2), 1965 S65, 1963 CA95 (Benly 150), 1968 CA77...
Not the best shot. Way better in natural light. I wasn't very good about documenting builds (before phones with cameras and forums to post on),...
Can't wait to see. I restored 2 CB-1s at the same time about 15 years ago. One as a side job and one for my wife. Both in 4th gen red. On the...
I like pulling shades out of the decals for color contrast. The grey out of the Honda wing on the tank would look great on the wheels, but maybe...
Well... I "get" to separate the carbs and replace the fuel tube o-rings. At least I just did this on my 1986 VFR750 this last summer, so the...
I wore my Schwantz the first time taking Freddie Spencer's riding school. Both Freddie and Nick Ienatsch gave me some shit. It was funny. The...
Arai RX7 Corsair, Colin Edwards Valencia Replica. Initially released, 2005, 2006? [ATTACH][ATTACH]
I'll look into that fuse box, thanks. Trying to work with what I have at the moment, and this tucks inside the fairing pretty good and still...
Rear inner fender, wire harness and ignition system installed. Radiator and oil cooler cleaned, fins straightened, light coat of paint and...
My very first helmet from my parents at 9 was an Arai (far right). My 16th birthday present was a Freddie Spencer Supervent ( upper left) and...
Wow, they've out-LAMED their previous level of LAME. What types of bikes they do they normally work on? There are very few people that are the...
More than likely it should fix your issue. You may have to adjust the short shift arm on the spline after changing everything a little to get it...
It is not. Rod should be straight. I have seen this a lot on the 500s, a little bend gets worse and worse (when people start jamming on the...
I've seen the inner duct color matched, and it looked pretty damn good. Still obviously a duct, just more subdued.
I personally would loosen the lower triple clamp bolts and fender bolts (brace to forks) and make sure that the front end isn't "bound" or twisted...
Separate names with a comma.
