According to the 5G service manual, #1 and #2 should be the same, #3 should be 20mm Hg below #1, and #4 should be 10mm Hg below #1 (all +/- 5mm Hg).
Got one of those, the VFR1100ST: [IMG]
Hauled the VFR1100ST out for a blast on Sunday over great dry roads, then tried my weather luck on Monday (in honour of the birthday of our...
One can only compare the VFR against the other bikes that you ride. For me, I really like the agility with stability across all road surfaces, the...
It's a long time since I owned an RC24, but would the bolt holes in the subframe be for the passenger grab rail (which US model Interceptors did...
[ATTACH] As you can see in the diagram, the flow from the engine goes to the radiator cap area on the right, then down through the two radiators,...
That is great news. Glad that we found your problem together, and learned a little in the process.
The RC24 came in two versions, the earlier one (FG, FH) has the 16" front wheel, the later (FJ, FK) has the 17" rim, as well as differences in the...
I took another look at that photo, and it looks like the screw from the carb boot band is making contact with the closing spring? Might pay to...
Are you really sure the throttles are closed? That 4th image looks like the butterfly is more open than I would expect for idle. AFAIK the only...
The clutch switch won't play any part in this, just the neutral or sidestand switches. The clutch switch only determines if the starter will fire...
If your bike is spewing coolant at 111, you need a new radiator cap. The cap is designed to hold 1.1 bar pressure and this increases the boiling...
On the bright side, at least your bike runs! Where are the throttle butterflies sitting with the twist grip closed? Are they all nearly 100%...
I agree; if the sidestand switch is OK then I would be looking at the wiring/plug.
Do we have to do the Hendon Shuffle if there is a Barnes Dance taking place? (Google it kids). I rarely ride in traffic, but if I am sitting at...
The first question would be where is the idle screw adjuster set? And are the throttle cables installed without enough slack?
This is an intriguing discussion. At the far end of the clutch pushrod is a radial ball bearing that allows the stationary pushrod to exert force...
Marke I think your connector is living proof of the terminal corrosion that Stoshmonster is talking about (I need one of those handy cleaner...
Absolutely correct! Out of interest I worked out that across my three bikes for the last 2 3/4 years when I bought my VFR I have averaged 48km...
I completed the refit of headers during the week once the parts arrived. Wasn't too bad of a job, needed some rubber hammer help for the rear...
Separate names with a comma.
