Check with Jack Flemming at roadstercycle.com, he has complete kits for Shindengen RRs, highly recommended.
Cams were replaced because of all the wear problems at the time, I had mine done on my original engine and the dealer didn't get one of the...
Wish mine was half as clean!
You are probably right, I experimented with a couple of spare carb boots, and it didn't take long to soften and swell up. May make installation a...
Most non-cable internet connections are asynchronous, they would rather devote a higher portion of the available bandwidth to downloads than...
Wish mine looked that clean, had my V&H pipes ceramic coated, it's a start.
I see a peek at your VF750 in the right edge of your photo, are those Kerker slip ons? I have a set on my '83, with Vance & Hines pipes.
The softer the cushion, the better the......
When I got new shorty levers, I found the bushing that connects the pushrod was worn (made of brass), that could be it.
The PC III doesn't need or read the O2 sensors, that is why dummy 330 ohm resistors are used to fool the ECU, the PC III provides the correct...
Low mileage 2007 in Bay Area. http://sfbay.craigslist.org/nby/mcy/4748374374.html
My ex-wife's bike [IMG] The NM4 is a CTX 700 in wolf's clothing, but the bite isn't any better.
If you decide to share a DSL connection you can use an inexpensive router to isolate networks and use a unique IP schema for your network.
Lights are control by relays, but low beam should normally be on. On the VFRs the two lower lamps are wired for low beam only, the high beams are...
Hope it works for you, definitely the best option. I used a hi gain yagi, with an amplifier to go over 60 miles for my HD digital network TV in...
Great deal, there is one for sale out here in the SF Bay area for $3600.00.
Looks great, not only do we have same bike/yr, but the same SUV, same color. My 03 is silver, probably because is was US bike.
I find my 2003 is sensitive to ambient temperatures, high temps usually occur in traffic and under 40 mph where the isn't enough air flow. Been in...
You can get full info at www.helibars.com
Got mine on eBay to, for $25 hard to go wrong. When I changed them, I found round brass connector to clutch plunger was worn, $11 at dealer.
Separate names with a comma.
