Completed a maintenance task on an '86 700 i'd been neglecting for years and years: pulled the 2 nuts at front to drain the cylinder block, very...
It's not a relay problem unless the connections under the plug on top of the starter relay are burned.
The most uncomfortable bike i ever sat on !
Yes, slides normally pulsate. Read the installation and tuning instructions that are provided by K&N/Dynojet with their jetkits and Factory Pro...
Carbs clean ??
Part of the charging circuit flows through the plug atop the starter solenoid, so unplug and inspect the bottom of it for signs of distress. I'd...
His first post and he's already kikkin my ass !! :livid::pig: Pump only supplies fuel when it senses lowering level in float bowls, not any...
Yes, some Honda V-twins and possibly V-4's do have bigger jets in front, the Honda Hawk NT650 for example. :eek-new: Also, be sure if your 4...
Don't use any cheap Chinese wheel bearings, including Allballs !!! :eagerness: Quality bearings are from Japan, Germany, USA, or Sweden ONLY...
With limited access to that area, you probably won't be able to install the shield unless the engine is out of the frame. :disturbed:
On my gen 2's I've got a method that works fine. Use the scissors jack under the mounts for centerstand, and lift the rear wheel 4-5". Then set...
A Yosh is a bit too loud to begin with, so if that fool wants to remove the baffle, he's crazy. Ignore him or tell him to grow up ! :crazy:
Be sure to loosen fork caps while still on the bike, and front axle bolt while bike is still on the ground. If the bottom fork bolt resists...
CDI on that bike is located just in front of and below the tail light. you may need to remove the sub-subframe that holds the seat lock latch...
What makes absolutely NO SENSE to me is that big panda replaced his failed K&N filter with the same brand !!!!! WHY ?
Key to long life on a 500 engine is keeping the revs below 9k. Above that, valve float and consequent damage.
Stand by Stand by for an announcement: Squirrelman's '97 VFR is ready to go back on the road after 11 years in storage !!!!!!!!!
It's nothing new. :tongue-new: Exotic European sportscars like Ferraris, Alfas, Jags were using Shell Rotella in the early 1960s ! I believe...
Changing the front/rear geometry isn't a good idea unless you know exactly what you're doing and why.
From my experience, biggest problem going 4 into 1 on a gen 2 is tuning out the slight flatspot that will tend to occur somewhere between...
Separate names with a comma.
