Too exotic for my budget, but if it's like a VFR700, the switch is on the lower rear clutch cover just below your foot whilst resting upon the...
Bottoming the front (except in the most extreme bumps) means you need stiffer springs for your weight.
Then check and top off again after it cools from your first 10 mile ride. :cool-new: Consider replacing your radiator cap as they can fail after...
If the testing procedure is similar to the temp gauge, you can test the fuel gauge by very briefly grounding the wire lead going to the tank...
Ally just saved your Canadian bacon ! :congratulatory:
Good post above !! It's also best practice to snap the throttle a couple times anytime a synch screw is moved to allow linkages and throttle...
Your bike has two pulsers, so you need to test each pair of wires going to them. Wiring diagram should show which pairs you test for 480 ohms....
What, like the voltage regulator ?? :tickled_pink:
Disconnect the plugs going to the instrument wiring and look for bad connections colored green or white, then spray with contact cleaner. It's...
Is't there a lowering mod that reverses the triangle or uses a different mounting bracket ??? :numbness: IF so you might be lookin at that. :redface:
I know i got one them in a bucket somewheres with sum empty beer cans :drinker: and i'd consider trading it for a plastic tail section in fine...
Makes no sense to ever pay more for any VF than for any VFR, even a little scratched and faded. Maybe you'd need a ride to see the differences +...
Black spray paint so seldom seems to correlate with a safe, sensible history..........
You need to record your key #s in a secure notebook to make things easier.
Larger tubes are fuel tubes, smaller are carb air vents.
Try a coating process.
Try green Scotchbrite and WD-40 (or similar) as a first attempt at cleaning, only using stronger methods later if necessary. Last step metal...
Head bearings are worn out and races dented by about 20-25,000 miles on almost all these bikes. :disturbed: Your initial maintenance should also...
Not quite ! :eagerness: First VFR's in 1986, a big improvement. [ATTACH]
Surprised Jamie didn't mention that bottom bolts come sealed with green locktite from factory. Important to use best-quality (not Chinese) 6mm...
Separate names with a comma.
