What rjgti said, but it's a cable, not just a screw="Idle speed adjustment cable". Looks like the same one used on 4th gens too.:cool:
Some idiot got ahold of them and ruined it all. Where are the missing parts ?? I shipped a complete '86 700 carb assembly back to Winnepeg after...
Next time she quits, pull the plugs and check for signs of excessive richness (black plugs) or leanness (almost-white plugs). A poor synch or low...
You'll never find the OEM build quality in any aftermarket lights. Honda supplied the short stalks you're looking for as OEM for the front of...
Soak in "Simple Green" or somethin similar for 24 hours, wash in hot water, blow dry with compressed air. Green gunk means it had fuel in it for...
Yeah, lack of backpressure is likely a contributing cause, but it should be curable with jetting and needle shims and alot of experimentation.
Connections in red plug atop starter relay need careful inspection too after it's unplugged. i hope Honda sacked a bunch of guys in the...
Relay is trouble-prone and superfluous, unneeded, useless baggage.
I think it's very doubtful that carb setting on your bike are causinmg high heat; far more likely a cooling system issue likie bad thermostat, bad...
Not easy to find a tach sensitive to 50 rpm + or - but idle drop procedure as outlined in FSM is the way to go. As an alternative, try this: with...
Could be a problem with the steering head bearings. If too loose or worn out (anything after 30,000 miles is suspect) front end shakes under...
Most of the ebay ones will work but they're awkward to fit cuz the high-current terminals are reversed compared with the original. Be sure your...
Test the starter relay for ohmage between the 2 terminals that send it power after removing the red plug (not the large terminals wired to...
Small filter above float needle seat may be clogged. Check petrol tank for signs of rust, and drain other carbs into paper towel, checking for...
Every switch i've seen is stamped "100" (C.) not 110.
Great find !! Don't ride in traffic until you've confirmed that thermoswitch for fan kicks in at about 2/3 temp scale, something that often fails...
I'[ll go through any VF/VFR carbs and fix whatever is wrong for just $175 + return shipping (usually less than $20). If parts need replacement,...
Yes, any Honda switch from another bike will work or there are generic autoparts store switches that fit too.
Cars will continue to run the electrik fan if engine temps are high, but bikes DO NOT. Ignition off, fan will be off too.
Leaky float needle/s........more likely than sticking float. Don't run the bike if oil is diluted with fuel !
Separate names with a comma.
