You got that, constant inspection of each carb as it moves toward mounting is most important. One set of eyes moving around and another volunteer...
I tried and their website was useless.
I hear he's waaaaay tired of wrenching.....at work !~ How much for the whole bike b4 you begin removing bit and pieces ?
Thanks, i'll give them a try.....
Ben, don't make too many judgements based upon that Ninja chain as it was worn out and overdue for replacement ! Remember that any chain...
You get them off and boxed up, and i'd be pleased to do the work.:cool:
[ATTACH][ATTACH]Their relays fail more often than the pumps themselves. Do the relay bypass at its plug, then listen for pump clicks when the key...
Easier carb mounting Use files and sandpaper on the intake side outer diameter to blend the flat outer lip back into a 45-degree section just...
Connection to airbox might not be tight enuff or filter not fitting properly ?
That's a real danger if you don't have things aligned before you start pushing..... [ATTACH] Best way to avoid that is by carefully watching...
CARB metal hates any alkiline molecules in cleaning agents, so NEVER allow water mixed with any dish or laundry detergent to remain in contact,...
Holding the bike vertical, START lifting only after you have determined (by slightly rocking the bike) that both centerstand feet are resting...
Can't be considered a VFR veteran until after you've replaced your second r/r ! :nelson:
Removing carbs, it helps to get the rears moving first. Don't try lifting the whole unit evenly. Heat helps. Don't detach the airbox bottom from...
A poor idea, especially in the rain !! Some things can be done but shouldn't .
Looking for info on any aftermarket availability, molded in shape, not O-rings. ?? :wink:
R/R isn't always at fault for low charging. You need to inspect 2 plugs before blaming it: 3-wire plug from stator to R/R and plug atop starter...
QUALITY gear doesn't come from China.
:welcome: :tongue: Drain and flush the fuel tank, check for rust. Change ALL fluids.
Blow air into one opening, and if air is blocked, that's the output side.
Separate names with a comma.
