Lower radiator switch controls fan.
"Just a fuse?" Not likely as something overloaded the fuse and caused it to blow. Fuses don't just wear out but respond to electrical faults.
Doesn't it plug into the airbox ?? look at the first photo.
HF ?? You got that right !
You need to find an old, established shop that's been around for at least 25 years and find a bald old man who loves 'cycles and get him to do the...
Maybe an intermittent problem with fuel pump or its relay ?? Just one leaky float needle will make for running/starting problems. I suggest that...
Yes, speedo cables do need occasional lube. If you can get the front end up, spin the wheel and listen for your noise.
I'd re-read post #2, then get busy lubing your speedo cable............... If you can get the front end off the ground and spin the wheel, you'd...
where do you ride ?? around any city roads or streets i know, a VFR is well over-qualified for it's roll of commuter or recreational use. Best...
Not quite correct, sir ! After the 2 wires going to the relay are connected at the plug, the pump is powered ONLY when the key is ON, so no need...
Rollin is quite correctly in referring to a plug that sometimes looks as pictured: [ATTACH] Also, many charging problems can be found within...
That's the fix i recommend as the manual switch, in parallel with the OEM switch, is the best solution. Engines are designed to run best within a...
Hold on, cowboy !! It's practically NEVER necessary to remove the airbox base from the set of carbs, and it should NOT be done to ease carb...
fuel filler cap vent blocked ?? carb float bowl vents not breathing freely ?? all your fiddling with the carbs might have messed up the synch....
Study the installation and tuning instructions included with K&N/Dynojet AND FactoryPro kits. Both have the essential tuning ideas and proper...
Plugged enrichment circuit pickup tubes?? Gotta be able to probe with a .012" steel wire to a depth of about 45mm to be certain the tubes are...
It's on the starter relay.
Ever try the trick of angling the boots (1/2 on, 1/2 off) to better align with carbs ?? [ATTACH] something to try if earlier efforts failed...
It always seems to help if you remove the slave and sprocket cover, then use a C-clamp to retract and hold the piston in. Also, try bleeding the...
No problem using JBWeld* to fill slide holes if you want to. If the bike won't run right with adjustable jetkit needles, it's much less likely...
Separate names with a comma.
