I'd be super-surprized if your average drooling, cud-chewing, spit-spouting local mufflerman could make the pipe you need !!!!!!! Not that simple.
Could be a dirty connection between wiring harness and instrument panel, a bad ground, loose or poor condition battery terminals.
Don't listen to THAT guy !! Drilling jets is totally foolish unless you're tuning at the race track. Wires poked through the jets as well as...
At what rpm does the oil light blink off ?? Proppa idle speed setting for your bike is close to 1200-1300 rpm.
IF you've heard the pump clicking after the key is turned on and BEFORE pressing the starter butten, then a PO has installed the pump relay bypass...
A very common problem on older Hondas that can cause overheating is a failed radiator thermoswitch. You need to know that the cooling fan...
The mileage on the bike needed to be mentioned in the first post for accurate replies. Wear is related to mileage, and anything much over...
On a bike that old, i don't see why anyone would NOT replace springs when they had clutch problems..........?? With weak springs, even new plates...
You might well need to be suspicious that that bike has been run low on oil while running, thus bearing damage, what ???>? How big is the hole ??...
NO !! You need to find the problem, not just throw random parts at it. Any decent cycle repair shop or dealership needs to check the...
Just did an oil change and you never saw the light on at idle before ?? Not enough oil, or maybe a 20W50 would be better for your hot climate.
lot of us oldtimers grew up with cars, and back then it was a good test of the generaTOR to disconnect THE BATTERY while running, but NOT ON...
Re-check coolant level under the rad cap (engine cold) and don't run without a proper thermostat !! 12345678910
Please take an MSF new rider training course !!!!!!!!!
It's a well -known fact...... All fueling problems were eliminated when Honda switched (1998?) from carbs to electronic, computer-controlled fuel...
How you gonna remove the cap without the key ???? I can tell you how to get the key code, but not in a public forum, so PM me if you're...
Fuel pump......if it clicks, it works. You need to pull off lines to prove fuel from tank flows to pump. Yes, if your pump is in working...
Some clamps have an small spacer between the two sides that limits tightening, and if you remove it, you might get what you need,
" unless I pull the clutch in all the way." So pull the clutch in; why wouldn't you, since that might be the problem ??
Using cheap crap like Taiwan or other Chinese poor quality garbage will damage your nuts, bolts and miscellaneous fittings, and will break, so...
Separate names with a comma.
