I discovered--much to my surprise--that the CDI can have a failure that causes only one cylinder to not get spark. You need to do resistance...
Take a VERY close look and compare all details of the replacement with the original piece. I doubt there are any significant differences that...
"Moose Jaw Honda??" You got a job ??? "Welcome to the parts department; here's your broom." Shipping and custons duty would pretty much...
Good luck, Matt, but i trust you did OK on the parts replacement. Again, inspect plugs to see if you can find one that's giving you trouble....
First, check all the fuses. After you test and eliminate the several wiring and component issues, then suspect the CDI. Refer to wiring...
Since it's electronic and built into the CDI, spark timing seldom or never gets out of whack, but you should check (with airbox off so you can...
IF you're a boy, your rack holds no interest for me.
Damn !! You guys who like to drink (like me) wouldn't it be fun to hang with TC in his shop ????? Anyone know his fave beer brand ?
Keep the whole bloody engine, Mate, no telling what you might need after the valves fall out.
Matt, i suspect you probably have one cylinder that's not firing. Judging from the vapor exiting from the mufflers, i'd check the cylinders...
It's possible to get a new chain set up before cutting to length or installing end link just by wraping it around rear sprocket (already run...
Pure synthetic has got to be the best cuz because it's the creation of modern engineering and SCIENCE, not some dead stuff left over from the...
[ATTACH][ATTACH][ATTACH] It's all been covered before, but: Because air can hide behind the slave cylinder piston, you might try removing...
Ecologically minded riders should be aware that Castrol=BP. Remember the corporate irresponsibility that caused the oil spill ??
Seems pretty clear that you needed to remove a few links...... It's always smart to place a new part next to the old one you're replacing and...
Be careful what wire size you use to grips as too small could melt down and cause a fire.
Say, Bomber, can you be sure that your Radian (I've owned a few and love them) didn't have a float/needle leakage problem ( somewhat common on...
Actually, unless youre arms and hands are really fat.......it's not difficult to get your hands close enough inside the V to access the synch...
OK, good explanation, but washers under needle or slots on the needle (another adjustment) also as well as throttle slide control the mid-range...
Things will go wrong quickly if you have not read and studied the manual, so get your download organized or actually buy the book on ebay or from...
Separate names with a comma.
