Just make sure that the washers under the retaining bolts are placed with the coppery-looking side UP. Also, you should bond the gasket to the...
Brake fluid absorbs moisture and turns to crap after 3-4 years, so above recommendations to flush and refill should go a long way toward...
If clutch plates rattling inside the basket is the cause, then an accurate throttle body synch could be the cure.
Save yourself the expense and frustration: this will probably never be a good-running bike again.
Is your petrol tank clean ??? Rust or dirt in there can get into float needle seat area and hold them open, causing the overflow from the vent...
Please let me know if you need any info or advice fixing your carb setup. One thing i've noticed is that the Keyster needles seem just a...
PHOTOS please !
It would be real easy to come up with a set of great-looking pipes that don't work well on your engine, bad scavanging, low gas speeds, flat...
Right !! Best thing is the toggle switch as the temp sensors are just as unreliable as the R/R, maybe more.
That's alot of cash--even in Canadian money-- but i have a Telefix fork brace on one of my '86VFRs, and it does make a difference. Must be...
You have admirable pipe bending and welding skills, Don, but any set of pipes is a compromise between tweeking low or high end power, and with a...
OH, Yeah, valve checks are "easy" after you partially drain the cooling system, unplug the fan and slip off the radiator to get to the front valve...
Busted fairings can almost always be fixed-----if you have ALL the bits and pieces. Plastic welding the proppa way or with a soldering iron or...
Dragone omitted to mention that MEK is a VERY dangerous chemical, rated as highly carcinogenic, so forget about using it unless your health...
This problem can be minimized by angling both the rear mounts slightly so there is a gap at the bottom where the screwdriver points. Start with...
Sure will !! Thanks to all the folks here who will tell the ugly truth about Honda's mistakes and save me from the flack attacks.
:welcome: Steering bearings need replacement at 35,000 mile intervals, so check yours. you'll need to flush and replace all fluids, but plug...
Dija know the mainjet holders are different front/rear ?? Slightly different heights of lowest holes.
A compression test is a necessity, but that model has too many potential problem areas to be a reliable ride. Find something newer. People all...
Float drop is not adjustable on streetbike carbs. In your case, since you did all that unnecessary work to split carb set, you now need to...
Separate names with a comma.
