STUDY the wiring diagram in the service manual; it should answer your question.
MONEY to burn is rare these days.......
Valve cover gasket ?? TRY cleaning the gasket area and using some silicone sealing material, but resist any attempt to over-tightening the hold...
IT coulda been lots worse.... wheelies are hell on steering bearings, wheel bearings, and fork seals.....grow up and stop showing off.
The Maier plastics co. sells lower fairings for '86/'87 VFR ....you could order direct or get them through Dennis Kirk catalog. 1-800-33Maier...
Drugs can be seriously misued in the wrong hands.....
Once the airbox is removed from carbs they can wiggle around and loosen O-rings sealing fuel lines, and any of several springs could pop out.
Like TOE said, you're in deep do-do if you remove airbox bottom from carbs! Don't attempt ANY operation unless you read and study the Honda...
THE PB Blaster should serve to loosen rust, just run the bike.
Because of the internal construction of the fuel pump it's not possible for fuel to flow through pump unless it's under power.......... you...
find out where it's dripping from. there are 3 places where fuel might likely leak: from vent tube ( bad float needle or incorrect float height...
HOW long does the air linger in the airbox???? How much cooling can be done in that fraction of a second?
NOW you know why the PO parked the bike ?? coolant in the oil usually shows on the dipstick...did u check ?
IT'S easy to screwup a good running bike that way......flatspots at certain rpms are common after pipe mods, probably need to rejet carbs.
AND check your tank for RUST using a flashlight.......not a match or candle. A rusty tank will clog carbs and cause the problem you...
unplug front and rear signals separately to locate the bad socket.....dash light will go out.
Stock or aftermarket signals?? Aftermarket Taiwan-made signals are very low quality, poor soldering, worst materials, can easily short or...
IT'S for people who don't have the riding skills necessary to handle a motorcycle........
Did you check voltage with engine running at about 5000 rpm....or at idle ??
NOT a good place for white wheels: brake dust collects mostly on right side, chain lube on the left. Best way i've found to clean is with a...
Separate names with a comma.
