I ALWAYS wear a backpack. Use it to carry water, tools, small spares, documents, raincoat, wire, electrical and duct tape, and use it to haul...
Really, that bike looks great, never subject to juvenile neglect or abuse, and if it runs as well as it looks............... you're golden !...
if i sacrifice the 5 cent deposit i can find an empty beercan in my backpack that, when crushed, does the same job and save 54 cents and not...
Here's a tip: If you can afford to ride a VFR, you can afford quality tools. So don't use anything made in Taiwan or ( the other) China cuz they...
Hey, at least this gent had the refinement, good taste, and money to go out on a modern bike, not some VF that woulda, shoulda stayed at home in...
>>>>>THAT was the odour of garlic; Gilroy is the garlic-growing capital of the entire world !
SHAME on Honda for making something that ridiulously complex for so little gain.....except to the dealers' bottom line.
I get it: if i wanted to throw money and time into an old bike it would be a BSA Goldstar or '72 Norton Commando. The oiling problem means that...
you'll spend more time working on that antique than riding it. What looked good then looks way outdated now unless overweight, underbraked and...
it's easy to drive them out with a medium-to large hammer and any long drift or long 3/8" or 1/2" drive extension, no fancy slide hammers or etc,...
Wiring is very simple; deciding where to mount the switch is hard. What is that fancy switch, Mil-Spec?....it's way overkill. The Home Depot= $4
Order from Ron Ayers/ Service Honda/ or somewhere in UK ?? maybe your dealer, Honda of Tallinn, has the parts on his shelf??:eek:
Dija also clean and regrease those slider pins??
Best tyre deals are the ones advertised monthly in the motorcycle mags. Otherwise, Dennis Kirk Co. has what you need and a damn good free...
Nice mod with better tyres for sure, and it's good that someone with the time and talent tried it. But getting the job done appears to have...
Remove the bulb and take it to any autoparts store....... if that fails, there's always The Dealer.
remove the 2 screws holding the switch together, remove either cable down at the carbs and the throttle tube will slide off
could be incorrect cam timing.......or wrong valve clearance setting
Seems like abuse to me, andi don't enjoy seeing any motorcycle being abused, much less a fine VFR! let the juvenile, amped-up, pierced and...
TDC point is extremely critical when setting valve timing, however not critial when setting or checking clearances as long as cam lobe is...
Separate names with a comma.
