sometimes people think they are filling their cooling system by filling up the reservoir: NOT CORRECT. Since the reservoir is only an...
Something different compared to cars is that the bike uses a wet clutch, so it's not as prone to wear by slipping. Part of the smoothness you...
check your owner's or service manual for STANDARD plugs, and use those unless you ride in temps below about 30 degrees F.
Something they seldom take time to do in shops but a careful owner SHOULD do every time is to pre-fill oil filter about 2/3 full before mounting...
Riding any bike--especially a high-powered sportbike--is an excercise in self-control and good judgement EVERY single second.
THATS the sign of a BIG crash, and i'd pull the entire steering head apart ASAP for full inspection of tripple-tree straightness and bearing/race...
change your plugs, and ditch the cold-weather ones. Cold weather plugs are too hot for regular-season riding and can damage things if the bike...
be sure to post meeting time and place when decided!!! Note: "L & J Honda Motorcycles," a maintenance and repair shop in the Buffalo area that...
ANYONE who's taken a close look at the new DN-01 has reason to suspect Honda has lost its corporate mind !!
Nasty, that is!! But don't all stolen bikes (or their parts) end up in Oakland??
smoke and sootyness COULD be caused by over-filled or fuel-diluted oil. When carbs are properly done, turning in each mixture screw almost all...
rubbing baking soda by hand on a well-wetted sheild will remove film; as always, rub only left-right, not in circles.
As a general rule-of-thumb i'd suggest: " ALWAYS check your charging volts before replacing a battery." 199Q knows alot about batterys and...
check the mixture screw on the sooty cylinder for a broken tip, and check that choke plunger is fully seated when OFF
that's a sign that you need to check for loose/burned/melted connections at R/R plugs and atop starter relay.....
OK, here's info someone from the HawkGT site sent: NAPA part #703-2443 or NAPA part # 703-1443 same cap, different pressure...
i've had great luck using a 40 watt large-tip soldering iron to melt/fuse pieces together, working from the inside, of course, but the odor is...
Welcome! Nice project bike, but you may be going a little overboard on your rebuilding plans since old Hondas come out of extended storage very...
no problem.....all carbs have open vent lines because the float bowls need to breathe, and debris is not an issue
Any equivalent rad cap for VFR that fits a car and can be bought at regular autoparts store??????
Separate names with a comma.
