midrange flat spots are often exhaust-related, so it might be informative if you could juggle with discs. try shimming your needles up and...
Stock or aftermarket exhaust??
>>>>> That's so true, but when i tried to state the same i had a trio of amped-up, self-righteous Socal morons attacking me in PMs like a...
Volts should be at least 13.5... Inspect the plug (under the fuel pump) that connects 3 yellow wires from the stator to the R/R for...
Where is the hole located, and what is the size?? Honda puts a small hole at the bottom of the pipe a few inches in front of the muffler to...
Visitors interested in nature should see Goat Island, about 4 blocks from the Buffalo Ave Hotel....where there are 3 varieties of squirrels, one...
ARAI .... has been doing it longer than anyone else, and their company philosophy and dedication to research and improvement can't be...
DON'T leave home without duct tape!
make sure you have a basic toolkit, some fuses, and a length of insulated wire, and duct tape ! Check that your cooling fan kicks in as it...
REALITY CHECK : IT can be Living Traffic Hell to cross borders when bridges are backed-up, and folks, this is the height of tourist season....
can't see how the con rod would not ( and possibly the crank) be damaged also
THE parts you need are probably not available new, and used parts are risky. RIP.....she's done forever !
one of the problems with adjusting valves on high-mile bikes is that the bottoms of the adjusting screws have usually been beaten flat, but they...
best advice you could get from somebody who has a VF series bike. I'd say have a good look at your cams.....because if there is evidence of...
yes, but you'll leave a small quantity of dirty oil at the bottom........
TOOT your horn, check your voltage !! Low charging voltage usually shows up as a weaker than normal horn sound. If your horn sounds weaker...
to do the job best u should not simply use the drain screw to remove oil from forks but remove forks from bike and drain them upside down over a...
broken chain can also wrap up around front sprocket and usually destroys the engine by ripping off bolts and their mounting points around sprocket...
did u try the no-hands deal with the old tyres?? i know there are tons of posts about gen4 wobbles with hands off...... It turns out that...
you'll get better results using a real "fork Oil' rather than a motor oil....cuz it's engineered specially for that specific application. if...
Separate names with a comma.
