Sort of sounds like an intake vacuum leak; if the MAP sensor on the back of the airbox gets unplugged (electrically or the vacuum hose is off) it...
If the bulbs are OK and the high beam "pass" button works, then most likely you have dirty contacts in the hi/lo rocker switch.
I would vote for replacing the seals in both the slave and the master. The slave cylinder might be scored or corroded, so pay attention to the...
The force needed to work the lever is a function of the hydraulics and the clutch springs working against each other, overlaid by any friction in...
I had exactly the same thing happen to my 99 last year. Glad you found the issue easily.
If you go to the other VFR site, the manuals are available as free downloads......
When you have the fork apart, run a tap through the thread in the cartridge base to get all the old threadlock out. I make sure that the damper...
RTV = room temperature vulcanising; basically a silicone sealant. Like this:...
Looking at the parts fiche, the rear cylinder head cover is only sold as a complete assembly. Easiest would be using some liquid gasket sealant or...
That's a bit of an open-ended question but I will take a punt and give you my 5 cents worth. 1. Forks get stiffer in proportion to the square of...
Did Honda change the angle of the downdraft into the heads on the later bikes to make it steeper relative to the cylinder? That would make the...
The idle adjuster is accessed through the hole in the right frame spar, with a philips head screwdriver. Good luck with your project.
[ATTACH]
I've always wondered about that point. The hoses are made to withstand high hydraulic pressures and the constant flexing from suspension...
The VFR forks are indeed cartridge type. SS-8 is also a 10W oil and the reference I have states 39.7 cP viscosity at 40C. I believe the PJ-1 may...
I did have some aftermarket bar ends on my last 800 and can't say I noticed much difference to the stock ones. Aftermarket parts often use an...
If you are a cheap bugger like me, get a piece of thin rubber (I use a bicycle inner tube) and pack out the cush drive if there is too much free...
Looks like a good project, welcome. Make sure you check the condition of the cam lobes and followers before spending too much elsewhere.
I rode my 5th gen yesterday for the first time in a few months, and actually do get a bit of buffet from the ZG screen which I did not remember.
You'll need to unscrew the 4 air funnels in the bottom of the airbox, and after that it just lifts out with rubber hoses attached, which you'll...
Separate names with a comma.
