It's a balance and compromise since more oil flow to top end = less oil pressure at bottom end crank bearings.
Use a dremel to cut a shallow slot then use a small screwdriver to back it out. Or, if you can find exactly the best screw driver with the...
Starting system safety lock-out circuits ?? : neutral switch, clutch switch, sidestand switch if so equipped, or the diode that controls it all ??
It's harder to adjust and set tapered bearings than OEM balls, so check there, as mentioned. Could also be loose front or rear axle nut or...
WELCOME !! How many miles on your bike ?? If you needed the aid of the choke to keep the bike running, it would have fouled the plugs fairly...
Geez !! One wire goes to battery + and the other to chassis ground or - battery terminal. Simple enuf ?? Need a diagram ?? What i use is a...
" What about rectifier/regulator? Could this be a possible cause? " Hell yes it could if your battery isn't being properly charged while...
Unless the oil tastes good, it's not good oil. If you are talkin motor oil it usually takes about 20 posts into the morass b4 one idiot calls...
Religion, US politics, Republicans vs. Democrats, gays, motor oil.....not on here, please, Bunkie. Someday i'll start a PROPER oil thread for...
What's good is the stator. 50-60 VAC is good output @ over 5000 rpm. Replace r/r and make sure grounds are clean. One problem is that Honda...
"Oscillation" Classic symptom of badly over-tightned steering bearings, much easier to mess up than OEM ball setup. Best done with front end...
Raw gas smell seldom comes from exhaust, but the filler cap has rubber seals that can deterioriate. Also, some fuel aroma is normal cuz,...
Good wire info, Don, but the larger the wire (as long as it's not over .012") the stronger, right ??
Thanks for the amusing squirrel story !! If you have an air compressor you can check condition of enrichment pickup tubes by blowing into...
Seppo can't 'elp it, matey. Been loyal fan of BBC 's EastEnders and the lads and lassies in Albert Square since 1987 !!!! Love that show !...
Another test is to use pliers to jump across the 2 big terminals atop the starter relay.......after you've verified trans is in neutral. This...
Fuse is an unlikely suspect unless naughty rodents have nibbled some wires and caused a short to ground. Just recently i was riding my '86 700,...
Don't fret, gentle rider, for Squirrelman hears your prayers...... You do need the properly stiff wire in the size recommended, but it may take...
Ride it until you do the synch. Most synch issues are most evident at and a bit above idle speed and at low throttle openings.
I do understand love and romance, Gordy, but have you ridden any bike made in the last 5 years ????? Then you'd have an idea what an antiquated...
Separate names with a comma.
