I have a 1983 VF750f. It is jetted with 110 and 112. I thought it strange that the '83 bike was not jetted with 128 main jets. The two original...
So, recently worked on carbs. Fuel is running, but right now bypassing the relay since it is dead. I got the bike to start, it idles and I let...
Main thread will be kept up on the VFRD site. Here's the copy and paste Looking to put together a group buy for replacement 4th gen carb vacuum...
I recently picked up an 86 VFR700. After the engine gets a chance to warm up the idle climbs way up to 4000(ish) rpm and never comes back down....
[ATTACH] Anyone know where this vacuum tube is supposed to attach to?
Ok so after much time on the forums i cant seem to find this anywhere. My 1991 Vfr has a problem when i give it throttle, let me explain. I was...
I have a 92 VFR (Canadian version) and I ordered new carb needle valve seats. The ones they sent have a 2.6 stamped on the top while the originals...
Howdy everyone, I picked up a nice low miles 86 VF500F that sat for a long time. Ran great, didn't idle. I'm currently giving the carbs a good...
Pulled the keihin CV carbs from my 86 vfr700. I want to remove the jet needle from the diaphram/piston assembly. The needle is held in by a...
Hello everyone! I just registered on this thread because I bought my first set of wheels about 3 weeks ago. For some reason I was getting...
The large hose on the left side of the carb, visible at the top of this image...where does it go?
I recently pulled the carbs off of my bike for cleaning and after finally freeing them from the rubber boots, there was a small rubber hose that...
So I'm relatively new to VFR but diving in head first into the shallow end of the pool. I've replaced all pads and rotors all around, swing arm,...
Hello, I just recently inherited a 1983 VFR750 from my dad who bought it brand new back in the day and I have been fixing a few things before it...
Hope I'm putting this in the right spot. So I got my 85 VF700F Interceptor last summer (after it had been changing hands on Craigslist...
I have an old motion-pro carb sync tool, with the mercury capilliaries and 5mm brass adapters. Last week one of the adapters snapped while on the...
OK, so I downloaded a .pdf shop manual (thx again, Betarace) and I just started browsing through the 577 pages of this behomoth when I realized...
I need the mechanics' opinions. My Gen2 700 is runnin' strange, idling rough and hesitating on take off. I need to know which is the better (and...
I finally got around to pulling the carbs on my 1986 VF500F. I believe in making sure I know what I am doing and where things go before I start to...
i came acrossed a 1986 vf500 from a salvage yard, they said it needed to be cleaned and it would run this is my first bike ever so far ive...
Separate names with a comma.